Painting A Dresser Using A Husky Spray Gun
Tricks, Ratschläge, Online, Reparieren, Landwirtschaft, Landwirtschaft Maschine
Decided to give spraying a dresser a shot. Video of unboxing a Husky spray gun and painting a dresser. Came out decent for a first time.
Bemerkungen
-
Good video, thanks! Helpful hint. .... I remove the canister to clean then reattach to run solvent/cleaner through the gun. makes it a wee bit faster, as I change paints often during a project :) Thanks though for the video, I just bought the Husky two sprayer/4 bottle set. LOVE IT!
-
Nice work!
-
Talk about doing it wrong. Bought the spray gun and THEN watched a video to see if it would work for me. Your video is exactly what I needed, thank you. Your dresser looks great, so now I'm hopeful that my "wrong" turns out right. LOL. Hope your team won! ;)
-
Great, thanks for showing start to finish including setup and clean up.
-
Bro you did 2 BIG BIG mistakes. If you use thicker PAINT use the 1.8 needle in the set. And turn the nosel 90 degree so you get a football shaped spray. Also when you use thicker PAINT in your gun ensure to remove the filter which is normally in between your GUN and Paint reservoir. Than you get the JOB done in no time. Also use Acetone to clean and thin your paint. It's a solvent and very cheap.
Also very important TIP : The pressure you have at your compressor is not the pressure you have at your gun. So get an inline pressure gauge for you next project and use the gun at the gun a pressure between 20-25 PSI that should give you the best results. On Clear coating you might adjust and ensure all FAN's on the gun are wide open :-) -
Cool, they say, not for latex paint, but that's what everyone uses them for, and they work. Use quality paint, like you did, and its a cheap HVLP paint system.
-
It got the job done but there was some simple mistakes
-
Thanks. You got me started on my project..
-
Great video. Steve, how difficult was it thinning the paint? We're there instructions on how to thin it?
-
Add the plumbers tape to the coupler....learned from that mistake, and YEA Mineral Spirits
-
What was it that you used to clean out your nozzle in the end? Mineral spirits?
-
Turn the air horns on the cap horizontally instead of vertically aligned. If they are vertically aligned your stroke should go from top to bottom otherwise you paint a 1 inch stripe
-
The nozzle tip has to be horizontal
-
you might want to be careful on your air hose line supply, I noticed you have a fairly small hose diameter, if that gives your problems you might need to get a slightly wider one for more air flow.
-
Thanks, Steve. I just opened up the box to my new Husky Spray Gun. You walked me through it; I'm ready.
I appreciate it.
By the way, the dresser came out very well. You're already a pro..
5m 43sLänge
68Bewertung