M-Audio Conectiv on Traktor 2.6 w/ Mk2 Control Vinyl

Tricks, Ratschläge, Online, Reparieren, Landwirtschaft, Landwirtschaft Maschine

1. please can u send me the conectiv drivers for OSX, couldnt download from any site!
2. i can´t able the scratch. but i see the timecode signal
3. good day friend,
   
   Forgive me if my message is not understood because the language is a problem , use the translator to write the message , hoping to understand me .
   
   I tried to run the Conectiv interface with software traktor as indicated by some manuals , but I have not managed , could you do me the favor to explain well the procedure to do so or if maybe you could send me mail software with settings and established , I would be very grateful .
   
   thanks and greetings from Colombia .
4. what did you select under the set-up wiazrd in traktor? my timecode option is showing disabled in Macbook Air on OS X...
5. what is that ringing sound?...that's horrible
6. thanks for the advise, going to have to try this out tonight. Got a new laptop and I was so pisst off when I found out they didn't have drivers for windows 8.1 for the torq connective. I really hope this works out cause I have a gig this Saturday, but I think you might of saved my life. I'll post if it works bro, thanks again.
7. Does anyone know where I can find m-audio torq to used with my old conectiv control vinyl... I have an older Mac that I was going to setup with it, and I have the drivers, but no software :)
8. do you know anywhere that is hosting connectiv drivers? im trying to instal my old Torq on OSX 10.9.5 for a friend after i upgraded to Serato. the mac drivers it shipped with are old. it shows as not connected in system prefs.
9. I am able to control the song with my timecode vinyls......I just get no output to my mixer. I know its wired correctly because if i were to turn the knob on my Conectiv to hear the timecode, it works.....my inputs and outputs look the same as yours...............Any ideas????
   
   thank you
10. works fine or is better use mk1 with torq? i have torq conectiv and don't know which traktor timecode should buy